Browsing by Author "Abidakun, O. A."

Now showing 1 - 2 of 2
  • Thumbnail Image
    Item
    Dika nut oil as base oil for lubricants—effect of processing conditions on physicochemical properties
    (John Wiley & Sons, Ltd, 2013-01) Abidakun, O. A.; Koya, Olufemi A.
    The paper presents a report on the effect of processing conditions of Dika nut oil on its physicochemical properties and also on the assessment of the oil for use as biodegradable lubricant. The oil was expressed mechanically from coarsely ground kernel meals at 3 and 9 wt.% moisture content (wet basis), preheated at 75, 100 and 150 °C for 10, 20 and 30 min. The plots showed that the chemical properties of the oil had quadratic and linear relationships with the heating temperature and heating time, respectively. At 95% confidence level, the free fatty acid content, the saponification, the iodine and the acid values of the oil were significantly affected by various processing conditions. The processing conditions therefore showed significant influence on the physicochemical properties of the oil and consequently on its suitability for use as lubricant. Copyright © 2012 John Wiley & Sons, Ltd.
  • Thumbnail Image
    Item
    Effect of expression conditions on the yield of Dika Nut (Irvingia Gabonesis) oil under uniaxial compression
    (ICCEM, 2012) Abidakun, O. A.; Koya, Olufemi A.; Ajayi, O. O.
    Efficient expression of Dika nut oil from the kernel is required for its subsequent use in producing comparatively cheap lubricant. Various factors responsible for proper oil expression include particle size, moisture content, heating temperature, heating time, pressing pressure and pressing time. Sundried Dika kernel ground to two particle sizes (fine: ≤ 1.4 mm and coarse: between 1.4 and 2.8 mm) were conditioned to moisture content of 3, 6 and 9 wt%. Considered in the study, are heating temperature ranging from 50 to 150oC in steps of 25 degrees Celsius and heating time of 5 to 25 minutes in steps of 5 minutes. Pressing pressure of 5 to 25 MPa in steps of 5 MPa and pressing time of 2 minutes interval were also considered. The maximum oil yield was then correlated with the processing conditions. Test results showed that coarse particle gave higher oil yield. Maximum oil yield of 72.2% of the available oil was obtained at 6% moisture content, heating temperature of 100oC and heating time of 10 minutes. Regression analyses of the oil yield with heating temperature, heating time, and pressing gave r2 values of 0.9678, 0.999 and 0.9128. The processing conditions therefore has significantly influence the quantity of oil obtained from Dika kernel.